Hello all,
It’s very exciting to see this effort blossoming…
Under Storage, the stripes were small enough that I was concerned I might press the wrong one when expanding the partition.
On the dial pad, what is that C for?
I couldn’t get data to work because I didn’t see a way to give it the correct APN.
I powered off, removed the µSD card, and went back into the ordinary p-boot/Linux world, and initially the display was flickery.
PS Do USB/ethernet/charging Just Work via the hub that comes with the 3GB PinePhone (once one learns how Sculpt OS works, at any rate), or would that require more drivers to be written?
Hi,
I couldn’t get data to work because I didn’t see a way to give it the correct APN.
Setting the APN is not yet supported.
PS Do USB/ethernet/charging Just Work via the hub that comes with the 3GB PinePhone (once one learns how Sculpt OS works, at any rate), or would that require more drivers to be written?
AFAIK the hub not been tested yet, I suppose charging could work. That being said we focused on getting the second EHCI controller where the modem is attached to to work first. At the very least integration work is needed to make use of the ethernet device in the hub if not changes to the USB driver.
Regards Josef
-
dogma＠disroot.org -
Josef Söntgen