Hi Cedric,
thanks for testing with the debug image.
No change for me -- boot-up takes a couple additional seconds (probably debugging/tracing enabled?) and the battery indicator says "AC" for a few seconds before displaying the percentage.
Yes, the image is build with serial logging enabled (if you attach the earphone jack serial cable to your PinePhone you will see all LOG messages).
I then proceeded to the setup steps,
- Expand... Confirm... still returns immediately
- Tapping "default" results in message "relabelling in progress"
displayed for about a third of a second, i.e. it returns immediately too.
FWIW, I have a bunch of SD cards/packages associated with this phone, EMTEC, Verbatim, etc. It seems the one I'm dd'ing the SculptOS image to is a 16 GB "Verbatim premium 80MB/s-read 533x (cl.1)" or some such.
Unfortunately I have no follow-up advice for now - but to make sure, former versions of Sculpt on PinePhone did not exhibit these issues (perhaps with the same SD card)?
(I normally use “SanDisk Ultra” cards, which did work fine so far.)
Regards Josef