By the way, I'm using acpi, and the driver says it supports my acpi table format.
On Wed, Apr 29, 2015 at 10:51 PM, Nobody III <hungryninja101@...9...> wrote:
After further investigation, I found that the AHCI driver is stalling on _irq_rec.wait_for_signal(); (ahci_device_base.h). This suggests that the interrupt mechanism may be at fault. Where should I go from here?
On Wed, Apr 29, 2015 at 3:33 PM, Nobody III <hungryninja101@...9...> wrote:
Months ago, I had issues with the AHCI driver not working with part_blk. I tested a simple scenario with AHCI and a non-writing version of test-blk-cli. It didn't work (test-blk-cli-nowrite didn't give any output), but the AHCI driver gave its normal output. I tested a slightly modified config using rom_blk instead of ahci, and it worked just fine. Any ideas about what might be wrong?