Hi Norman, the serial output I sent you in the previous mail is for high capacity SD cards.
Best Regards, waldo
On 04/09/15 04:52, Norman Feske wrote:
Hello Waldo,
[init -> test-blk-cli] reading block 0 - 131071, 246 per request [init -> sd_card_drv] -> index=0x00000012, arg=0x00000000, rsp_type=2 [init -> sd_card_drv] command timed out [init -> sd_card_drv] Read_multiple_block failed, Status: 0x01ff0207 [init -> test-blk-cli] Test failed! [init -> test-blk-cli] couldn't read block 0 - 246
you seem to be using a non-HC SD-card. So far, the driver has been used and tested with high-capacity (HC) cards only. So you are walking on new ground. But just to double check that we are not entirely on the wrong track, may you give a high-capacity card a try?
I suspect that the driver issues commands not understood by your standard-capacity card. For example, as far as I remember, the block addresses are specified in differently between the standard and high-capacity protocol versions. But there may be also other subtle differences between the protocol versions. To solve this issue, you may need to review the SD protocol specification [1] for the standard-capacity version and compare the SD protocol code [2] against it.
[1] https://www.sdcard.org/downloads/pls/part1_410.pdf [2] repos/os/src/drivers/sd_card/sd_card.h repos/os/src/drivers/sd_card/rpi/sdhci.h
Best regards Norman