I'm try to get a basic Genode setup working on a Beaglebone Black (TI AM335x processor). I'm using a version of u-boot specifically built for the Beaglebone Black from Robert Nelson's eewiki pages. The only modification I made was to allow for elf file commands.
Carefully following how the PandaBoard and the imx53 platforms were build I successfully built from base-hw an elf image for run/nested_init and loaded that onto an SDCard which contained the two stages of u-boot. (Previously, I had succesfuly built a helloworld test version of Fiasco.OC and successfully manually booted it from an SDCard with the same MLO and u-boot.img files. So the basic process of booting an elf image file works.)
The elf image is built to load and 0x81000000 with u-boot using the space from start of SDRAM at 0x80000000. The elf file header has an entry point address of 0x81004DC0. Booting the Beagleboard into u-boot from the SDCard, manually loading the elf image file to the load address above, and giving it a"go" command to the entry point address, I get an "application terminated" message as shown below in the console output through minicom: . . . *U-Boot# load mmc 0 0x81000000 image.elf** **reading image.elf** **604700 bytes read in 73 ms (7.9 MiB/s)** **U-Boot# go 0x81004dc0** **## Starting application at 0x81004DC0 ...** **## Application terminated, rc = 0x8108C004** **U-Boot# *
At termination, the output above shows rc to be pointed at 4 bytes beyond the start of the bss section of the image.
I would have expected to see at least some Genode core debugging messages, at least. Is core not being executed at the entry point?
I believe I have the Board_base stucture and cores cpu, pic, platform_support, timer and tlb files correctly set up for the AM335x.
Thank you for any help you can provide.
Bob Stewart