12 Jun
2024
12 Jun
'24
6:43 a.m.
Welcome to the list, mntn!
you're right, we enabled Sculpt OS on the MNT Reform notebook and its i.MX8M module. Unfortunately, this is not the same SoC as in the Pocket Reform, which uses i.MX8M Plus. Thus, a current Sculpt OS image will not run unmodified on your Pocket. But, as soon as we get our hands on one of those devices, we are going to look deeper into SoC as well as peripheral support and make Sculpt fit for it.
Regards
--
Christian Helmuth
Genode Labs
https://www.genode-labs.com/ · https://genode.org/
https://floss.social/@genode · https://genodians.org/
Genode Labs GmbH · Amtsgericht Dresden · HRB 28424 · Sitz Dresden
Geschäftsführer: Dr.-Ing. Norman Feske, Christian Helmuth
On Tue, Jun 11, 2024 at 00:48:01 CEST, mntn via users wrote:
> Hi all,
>
> I am interested in trying Sculpt on the MNT Pocket Reform. I suspect
> that the build for the MNT Reform may be adequate for this since it
> uses the same i.MX8M processor module used by the original Reform.
>
> The most obvious differences to me are the change in resolution
> (1920×1200 versus 1920x1080 on the original Reform), and the RP2040
> system/keyboard controller. There may also be other differences in the
> components on the system board, but the Pocket Reform documentation is
> still in a rough state, and as an electronics novice I had a hard time
> parsing the relevant differences.
>
> Has anyone tested this out yet? I am happy to try when I receive my
> Pocket Reform.
> _______________________________________________
> users mailing list -- users@lists.genode.org
> To unsubscribe send an email to users-leave@lists.genode.org
> Archived at https://lists.genode.org/mailman3/hyperkitty/list/users@lists.genode.org/mes...