Status of Sculpt on MNT Pocket Reform

Hi all,

I am interested in trying Sculpt on the MNT Pocket Reform. I suspect that the build for the MNT Reform may be adequate for this since it uses the same i.MX8M processor module used by the original Reform.

The most obvious differences to me are the change in resolution (1920×1200 versus 1920x1080 on the original Reform), and the RP2040 system/keyboard controller. There may also be other differences in the components on the system board, but the Pocket Reform documentation is still in a rough state, and as an electronics novice I had a hard time parsing the relevant differences.

Has anyone tested this out yet? I am happy to try when I receive my Pocket Reform.