AHCI not working on real hardware

[Nobody III]

By the way, I'm using acpi, and the driver says it supports my acpi table
format.

On Wed, Apr 29, 2015 at 10:51 PM, Nobody III <hungryninja101 at ...9...>
wrote:

> After further investigation, I found that the AHCI driver is stalling on
> _irq_rec.wait_for_signal(); (ahci_device_base.h). This suggests that the
> interrupt mechanism may be at fault. Where should I go from here?
>
> On Wed, Apr 29, 2015 at 3:33 PM, Nobody III <hungryninja101 at ...9...>
> wrote:
>
>> Months ago, I had issues with the AHCI driver not working with part_blk.
>> I tested a simple scenario with AHCI and a non-writing version of
>> test-blk-cli. It didn't work (test-blk-cli-nowrite didn't give any output),
>> but the AHCI driver gave its normal output. I tested a slightly modified
>> config using rom_blk instead of ahci, and it worked just fine. Any ideas
>> about what might be wrong?
>>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.genode.org/pipermail/users/attachments/20150429/63209484/attachment.html>