e1000 nic driver problem

[Christian Helmuth]

Hello,

On Fri, Jul 01, 2016 at 08:46:35AM +0200, Sebastian Sumpf wrote:
> On 07/01/2016 08:25 AM, john stokes wrote:
> > on running it real x86 hardware first two penguins are shown then some
> > lines like
> > [ 0.1234] ...............
> > [  0.2567]........................
> > .................................................
> > ....................................................
> > .........................................,..........
> > [ 2.98745] genode blk-driver is loaded
> > then booting hangs up there without showing any error message
> > but after removing nic_drv support it shows two more lines below
> > blk-driver loaded
> > mount everything
> > setup networking
> > and then autologin terminal of l4linux appears
> 
> This, most likely, implies that dde_ipxe did not come up for the rtl8169
> card. The thing is, we cannot test this card over here, since we don't
> own one. Is there a way you could provide the serial (UART) log output?
> Console only is unfortunately not sufficient here. So, for now I would
> leave 'nic_drv' commented.

In addition to Sebastian's advice I suggest using a more simple test
case for debugging dde_ipxe (like run/lwip or run/netperf_lwip) and
posting the log here.

Regards
-- 
Christian Helmuth
Genode Labs

http://www.genode-labs.com/ · http://genode.org/
https://twitter.com/GenodeLabs · /ˈdʒiː.nəʊd/

Genode Labs GmbH · Amtsgericht Dresden · HRB 28424 · Sitz Dresden
Geschäftsführer: Dr.-Ing. Norman Feske, Christian Helmuth