u-boot files - device specific?

[Ivan Loskutov]

Hello Aditya,

Yes, u-boot is board specific. You need to get sources of the u-boot,
configure it and build for your board. After that setup bootcmd in u-boot
(you can do it over serial console or hardcode it in board config).
For booting image.elf you need enable CONFIG_CMD_ELF in board config.
Genode build system can make uimage automatically. Just add SPECS += uboot
to etc/specs.conf

--
Ivan Loskutov



2013/7/8 Aditya Kousik <adit267.kousik at ...9...>

> Hello,
>
> I'm trying to run Genode on an i.MX6. And I've tried copying uImage. But
> that doesn't seem to be enough. I came across this :
> http://comments.gmane.org/gmane.os.genode.devel/813
>
> Your set of u-boot files, is it pandaboard specific? or can the MLO,
> u-boot.bin be copied to any device and booted?
>
> What's the procedure of booting from using the image.elf? (So far, i ran
> mkimage and created a uImage file. But that's obviously not enough. What's
> missing?)
>
> Thanks and regards,
> Aditya
>
>
> ------------------------------------------------------------------------------
> This SF.net email is sponsored by Windows:
>
> Build for Windows Store.
>
> http://p.sf.net/sfu/windows-dev2dev
> _______________________________________________
> Genode-main mailing list
> Genode-main at lists.sourceforge.net
> https://lists.sourceforge.net/lists/listinfo/genode-main
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.genode.org/pipermail/users/attachments/20130708/e6eafa83/attachment.html>