Hello. I am experiencing a network issue in Sculpt OS. Wired connection is established, and the computer gets an IP address assigned dynamically (e.g. 192.168.1.6), RAM FS is activated and in use, but I cannot download anything from the depot (using any source). Fetchurl keeps trying, and these messages can be seen in the log:

Libc RNG not configured

Fetchurl got stuck, respawning (it’s shown multiple times)

Packet operation = 0 failed (finally, I get this one)

 

I’m testing on bare metal. I have tried various network card combinations (Intel / Realtek) as well as various different motherboard / CPU configurations – the result is still the same. I tried Sculpt 20.02 and compiled 20.03 from the sources – again, the result is the same. Also, I tried disconnecting and reconnecting – still the same.

 

I have these network cards, that should be compatible as stated in the manual (E1000), but they yield the same results: Intel PRO/1000 MT (PCI)

Intel PRO/1000 GT DESKTOP (PCI)

 

Motherboard / CPU combinations:

Asus P5W64 WS Pro (classic BIOS, AHCI, VT-x) + Intel Xeon X5460

Asus Sabertooth X58 (classic BIOS, AHCI, VT-x, VT-d) + Intel Xeon X5650

Asus M5A97 LE R2.0 (UEFI BIOS, AHCI, IOMMU) + AMD Phenom II X6 1055T

 

What should I do to fix the problem? Is there anything I missed in configuration?

 

On a side note, if I use bridged networking inside Virtualbox on Ubuntu (trying to rule out motherboard incompatibility), the results are exactly the same. I downloaded Arora using NAT networking and hard drive FS depot, and then tried bridge networking to see if the culprit is in fetchurl, but Arora also cannot access websites. Since I want to test Virtualbox and Seoul on Sculpt OS, and nested virtualization results in a black screen for either of them, I need to go bare metal.

 

Best regards,

Dima Sokolov